Front Interconnection (patch cord side)
24/48 eight-position or nine-position RJ-45 unshielded modular jacks. Use of patch cords with RiT CLASSix RJ-45 plugs is recommended.
Back Interconnection (cabling side)
24/48 eight-position 110 and Krone tool-compatible blocks, accept 22-24 AWG wires and stranded 24-26 AWG. Rated for up to a minimum of 200 retermination
Note: Termination tools must be ordered separately.
Cable Routing and Clamping
Cable retention fixture is available for enhanced cable strain relief using cable ties. 4.8mm wide ties, such as PANDUIT P/N PLT 25, are recommended. Cables-ties can be ordered from RiT.
Interconnection to RiT’s PatchView system (in selected models)
Two 14-pin headers on the back of the PV panel are used for connection to PatchView Scanners. There is only one 14-pin header on PVMax panels. Select Scanner to Group B Patch Panel Attachment Cord according to the required length. The scanning signal is transmitted over pin 9 of the RJ-45. Pin 9 exists in nine-position RJ-45 jack and plug designs, used for these patch panel models. A special patch cord, SMART Jumper, including an extra wire and special RJ-45 plugs is needed.
Indicators (in models adapted to PatchView only)
Port identification indicators – 24/48 red LEDs. Connected ports are identified by a pair of activated LEDs. A single port can be identified and the corresponding LED activated by a remote control command from the network management station.
Conforms to ANSI/TIA/EIA-568-B.2-1, ISO/IEC 11801 2nd edition (2002) and CENELEC EN50173 (2002) for Category 6/Class E.